===== Trendnet TPE-082WS V1.2R =====

The switch is a 8 + 2-port Gigabit L2 switch with up to 75 Watts of PoE+ power on the 8 Gigabit ports.

{{ wiki:trendnet:tpe-082ws.jpg?200}}

==== Hardware ====
  * [[rtl838x|RTL8380M]] SoC
  * Macronix MX25L25635F 32MB flash
  * Nanya NT5CC256M8IN-D1 256MB DDR3 SDRAM
  * Realtek RTL8231 GPIO extender/LED driver
  * Nuvoton ARM microcontroller
  * Broadcom BCM59121B0KMLG PoE controller

 2 Uplink ports are SFP cages which support 1000 Base-X mini GBIC modules.
 Power is supplied via a 54V 1.67A barrel connector.
 
==== Pinouts ====
=== Soc UART ===
The UART is broken out to populated header J8:
  * J8.1 (left): 3.3V
  * J8.2: TX
  * J8.3: RX
  * J8.4: GND

=== PoE UART ===
The secondary UART on the SoC is used to communicate with the microcontroller to manage PoE. The communications are accessible from J9, which is in the microcontroller's power domain. Note that the SoC is in an isolated power domain, so avoid connecting the VCC or GND lines together.

  * J9.1: VCC, 3.3V
  * J9.2: TX (microcontroller to SoC)
  * J9.3: RX (SoC to microcontroller)
  * J9.4: GND

=== Nuvoton SWD ===
J10 is an SWD header to program the Nuvoton Chip.
==== Board details ====
Based on the board pictures this device appears to be identical to the D-Link [[DGS-1210-10P]]

{{wiki:trendnet:tpe-082ws_top.jpg?200}}
{{wiki:trendnet:tpe-082ws_bottom.jpg?200}}

===== Firmware =====

The switch ships with a bootloader based on Realtek's SDK for RTL83xx SoCs and Linux 2.6.19 based on Realtek's SDK. It has a web interface for all management functions.
The board identifies as RTL8380M_INTPHY_2FIB_1G_DEMO (Port Count: 10) for the Realtek SDK.

==== OpenWrt Support ====
Since the hardware appears to be identical to the [[DGS-1210-10P]] with 256MB of RAM instead of 128MB support with similar features should be a matter of providing a modified DTS file.

===== References =====
  * [[https://www.trendnet.com/support/support-detail.asp?prod=215_TPE-082WS | Product page ]]