D-Link DGS-1210-10 (rev F1)
The DGS-1210-10P (rev F1) is a 8 + 2-port Gigabit L2 switch. This model is part of the DGS-1210 series line-up.
Hardware
- RTL8380M SoC
- Macronix MX25L25635F (32MB flash)
- (128MB DDR3 RAM)
- RTL8231 GPIO extender to control the port LEDs, system LED, and a reset button. The button is software controlled.
2 Uplink ports are SFP cages which support 1000 Base-X mini GBIC modules.
Power is supplied via 100-240V AC type C13 connector.
An unpopulated Serial header is found at J6. Pins are Vcc(3.3V, Square), TX, RX and GND. Serial connection is via 115200 baud, 8N1.
Pin-outs
Soc UART
- J6.1: VCC, 3.3V (square pad)
- J6.2: TX
- J6.3: RX
- J6.4: GND
Board details
Does anyone have any idea what J13 might be for? Is it possibly for an optional RJ45 console port?
Firmware
The switch ships with U-Boot based on Realtek's SDK for RTL83xx SoCs and ucLinux 2.6.19 based on Realtek's SDK. It has a web interface for all management functions. The board identifies as RTL8380M_INTPHY_2FIB_1G_DEMO (Port Count: 10) for the Realtek SDK.