Differences

This shows you the differences between two versions of the page.

--- dgs-1210-10p [2021/09/19 18:57] – [Hardware] clarify some hardware details, include R1 info pfertser
+++ dgs-1210-10p [2022/04/25 15:52] (current) – Tag with JTAG svanheule
@@ Line 24: / Line 24: @@
 === Soc UART ===
-  * J3.1: VCC, 3.3V (square pad)
+  * J8.1: VCC, 3.3V (square pad)
-  * J3.2: TX
+  * J8.2: TX
-  * J3.3: RX
+  * J8.3: RX
-  * J4.4: GND
+  * J8.4: GND
 === PoE UART ===
@@ Line 49: / Line 49: @@
 ==== OpenWrt Support ====
-There is complete hardware support in an experimental OpenWrt branch. Of the L2 features, port isolation, 4096 VLANs, Local Port Mirroring, EEE are supported. There is support to do a basic configuration of PoE, advanced features such as prioritizing power for ports is not supported so far. Media change is detected on the SFP cages for fibre optic cables, however after hot-swapping an SFP module, manual setup is needed. There is no support to read the SFP ID/Sensor data via I2C.
+There is complete hardware support in an experimental OpenWrt branch for F1 revision (R1 is in the works). Of the L2 features, port isolation, 4096 VLANs, Local Port Mirroring, EEE are supported. Support to do configuration of PoE+ (including prioritizing power for ports) is possible with [[https://patchwork.ozlabs.org/project/openwrt/patch/20210511152243.1167160-1-john@phrozen.org/|realtek-poe]]. Media change is detected on the SFP cages for fibre optic cables, however after hot-swapping an SFP module, manual setup is needed. There is no support to read the SFP ID/Sensor data via I2C.
 Original features such as cable integrity tests, offloaded remote mirroring and Port-ACLs are not yet supported.
@@ Line 56: / Line 56: @@
   * [[https://www.dlink.com/en/products/dgs-1210-10p-10-port-gigabit-smart-managed-poe-switch | Product page ]]
-{{tag>dlink-dgs-1210}}
+{{tag>dlink-dgs-1210}} {{tag>jtag}}