Differences

This shows you the differences between two versions of the page.

--- mestechs_msg9424 [2022/05/28 22:50] – vchrizz
+++ mestechs_msg9424 [2023/02/26 15:03] (current) – Add more pictures oliver
@@ Line 17: / Line 17: @@
     * [[RTL8231]] GPIO extender to control the port LEDs
     * 3x RTL8218D 8x Gigabit PHY
+    * [[https://datasheetspdf.com/pdf-file/964696/SDMC/DM2016/1|Software Protect IC DM2016]]
+Uplink ports are SFP+ cages which support 10GBit Base-X mini GBIC modules.
 ===== Pictures =====
@@ Line 26: / Line 29: @@
 ==== Internal ====
 {{wiki:mestechs:img_6081.jpg?200}}
+{{:pxl_20230218_163625714.jpg?200}}
 {{wiki:mestechs:img_6089.jpg?200}}
-{{::wiki:mestechs:img_6136.jpg?200}}
+{{wiki:mestechs:img_6112.jpg?200}}
+{{wiki:mestechs:img_6136.jpg?200}}
+{{:pxl_20230225_170933045.jpg?200}}
+{{:pxl_20230225_170959496.jpg?200}}
+{{:pxl_20230218_172419528.jpg?200}}
+{{:pxl_20230218_172454620.jpg?200}}
+{{:pxl_20230218_172445723.jpg?200}}
+{{:pxl_20230225_172756640.jpg?200}}
 ===== Technical Information =====
@@ Line 375: / Line 386: @@
   * put zyxel_xgs1250-12-initramfs-kernel.bin in the tftproot directory of your running tftpserver
   * connect to the switch via serial (115200 baud 8n1)
-  * (re)boot your switch and press escape in serial terminal
+  * (re)boot your switch and press escape in serial terminal in the bootloader at the prompt "Hit Esc key to stop autoboot"
   * in serial terminal run command: **rtk network on**
   * in serial terminal run command: **tftpboot 0x84f00000 192.168.1.2:openwrt-realtek-rtl930x-zyxel_xgs1250-12-initramfs-kernel.bin**
@@ Line 446: / Line 457: @@
 RTL9300# # tftpboot 0x84f00000 192.168.1.2:openwrt-realtek-rtl930x-zyxel_xgs1250-12-initramfs-kernel.bin
 Using rtl9300#0 device
-TFTP from server 192.168.1.3; our IP address is 192.168.1.1
+TFTP from server 192.168.1.2; our IP address is 192.168.1.1
 Filename 'openwrt-realtek-rtl930x-zyxel_xgs1250-12-initramfs-kernel.bin'.
 Load address: 0x84f00000