Differences

This shows you the differences between two versions of the page.

--- ms108eup [2025/03/31 05:26] – created raylynnknight
+++ ms108eup [2025/04/04 03:16] (current) – Add images raylynnknight
@@ Line 1: / Line 1: @@
-====== Netgear MS103EUP ======
+====== Netgear MS108EUP ======
 {{https://www.netgear.com/media/switches_ms108eup_g1_tcm148-132697.jpg?200}}
-The MS103EUP is a 8 Multi-Gigabit (2.5G) L3 switch with up 4 PoE++ and 4 PoE+ capable ports for up to 230W of power.
+The MS108EUP is a 8 Multi-Gigabit (2.5G) L3 switch with up 4 PoE++ and 4 PoE+ capable ports for up to 230W of power.
 ===== Hardware =====
@@ Line 24: / Line 24: @@
 The other is labeled 'Power', and is used to indicate the device status. This LED appears to be an RGB LED, although it is currently unclear how the three colours are controlled.
 All ports have a two-pin bi-color LED, used to indicate the link status: green for 2.5G, yellow for 1G/100M. PoE status bi-color LEDs are also available, with green used to indicate the remote device is PoE powered, and yellow to signal a PoE fault status.
+==== Board details ====
+{{wiki:netgear:netgear_ms108eup_top.jpeg?200|MS108EUP Top}}
+{{wiki:netgear:netgear_ms108eup_bottom.jpeg?200|MS108EUP Top}}
@@ Line 44: / Line 49: @@
 ===== Firmware =====
-different versions of GPL firmware are available from [[https://kb.netgear.com/2649/NETGEAR-Open-Source-Code-for-Programmers-GPL | NETGEAR Open Source Code for Programmers (GPL) page ]]
+different versions of firmware are shown on the [[https://kb.netgear.com/2649/NETGEAR-Open-Source-Code-for-Programmers-GPL | NETGEAR Open Source Code for Programmers (GPL) page ]], but all link to the same download.
 The switch ships with a bootloader based on Realtek's SDK for RTL93xx SoCs and Linux based on Realtek's SDK. It has a web interface for basic management, including firmware updates.