software:broadcom_poe_control_protocol

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
software:broadcom_poe_control_protocol [2022/06/15 18:56] – [Get port overview] Match field name in table with frame description svanheulesoftware:broadcom_poe_control_protocol [2024/01/11 18:23] (current) – Add 802.3bt port power-up modes svanheule
Line 297: Line 297:
   * Reply: ''{ [port] [error] }''   * Reply: ''{ [port] [error] }''
  
-Descriptions for port modes 0-3 come from the Netgear firmware. Modes 3, 5 are used by Ubiquiti.+Descriptions for port modes 0-3 come from the Netgear firmware. Modes 3, 5 are used by 802.3at devices from Ubiquiti. 802.3bt modes are most likely not supported on pre-802.3bt hardware.
  
 ^ Field ^ Size ^ Description ^ ^ Field ^ Size ^ Description ^
 | port | 1 | Index of port to configure | | port | 1 | Index of port to configure |
-| mode | 1 | ''00'': 802.3af \\ ''01'': legacy mode, for high inrush current devices \\ ''02'': pre-802.3at \\ ''03'': 802.3at |+| mode | 1 | ''00'': 802.3af \\ ''01'': legacy mode, for high inrush current devices \\ ''02'': pre-802.3at \\ ''03'': 802.3at  \\ ''04'': pre-802.3bt \\ ''05'': 802.3bt |
  
 ==== Set port mapping ==== ==== Set port mapping ====
  • software/broadcom_poe_control_protocol.txt
  • Last modified: 2024/01/11 18:23
  • by svanheule