This is an old revision of the document!
Zyxel XGS1250-12
The XGS1250-12 is a 11 + 1-port Multi-Gigabit L3 switch. It has 8 Gigabit ports, three 2.5/5/10GBit Ethernet ports and one SFP+ 10GBit uplink cages.
Hardware
- RTL9302B SoC
- Macronix MX25L12833F (16MB flash)
- Winbond W613GU6MB-12 (128MB DDR3 SDRAM)
- RTL8231 expander in shift register mode for the port LEDs
- 8×GbE via RTL8218D PHY
- 3× AQR113C NBase-T PHYs
- One SFP+ uplink port
Power is supplied via a 12V 2A standard barrel connector. At the right side behind the grid is UART serial connector. A Serial header can be connected to from the outside of the switch trough the airvents with a standard 2.54mm header. Pins are from top to bottom Vcc(3.3V), TX, RX and GND. Serial connection is via 115200 baud, 8N1.
Board details
============================ Board Configuration ============================ ====== Port ================== Type Usr Phy Media Speed Duplex Attr ----------- ---- ------- ----------- -------------- -------- ------- 1000M 1 (0) 0 Copper (A) ALL Auto 0 1000M 2 (0) 1 Copper (A) ALL Auto 0 1000M 3 (0) 2 Copper (A) ALL Auto 0 1000M 4 (0) 3 Copper (A) ALL Auto 0 1000M 5 (0) 4 Copper (A) ALL Auto 0 1000M 6 (0) 5 Copper (A) ALL Auto 0 1000M 7 (0) 6 Copper (A) ALL Auto 0 1000M 8 (0) 7 Copper (A) ALL Auto 0 10G 9 (0) 24 Copper (A) ALL Auto 0 10G 10 (0) 25 Copper (A) ALL Auto 0 10G 11 (0) 26 Copper (A) ALL Auto 0 10G 12 (0) 27 Fiber (F) 10G (F) Full 0 ====== Fiber ================= Fiber Port Number: 1 ------------ Fiber Detect LPort Present MediaChg OE Status LOS Status ------ -------- --------- ---------------------- ---------------------- 11 OE None Enabled (GPIO:INT_16) Enabled (GPIO:INT_17) ------------ Fiber Optical LPort I2C DEV I2C TYPE ID Delay SCK SDA ------ -------- --------- ----- ------- ------ ------ 11 2 8 BITS 0x50 50 INT_8 INT_10 ------------ Fiber TX Disable LPort Method ------ ------ 11 GPIO(INT_15) ====== Button ================ ------------ Reset Button GPIO: INT_22 Timer: 3(sec) Action: Reboot Timer: 6(sec) Action: Restore Factory ====== Led =================== SYSTEM ON [ASIC(G)] OFF [ASIC(G)] BLINK [ASIC(G)] Port ON [ASIC(P)] ON C2 [ASIC(P)] OFF [ASIC(P)] AUTO [ASIC(P)] ====== Reset ================= Type: GPIO GPIO: INT_21 ====== WatchDog ============== Type: REG