Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
all8208m [2020/09/27 15:46] – [Hardware] Mention reversed TX and RX markings. obi | all8208m [2021/02/03 16:49] (current) – Correct the spelling of the OpenWrt project name pepe2k | ||
---|---|---|---|
Line 3: | Line 3: | ||
{{ wiki: | {{ wiki: | ||
- | The SG8208M is a 8-port Gigabit L2 switch, marketed as " | + | The SG8208M is an 8-port Gigabit L2 switch, marketed as " |
===== Hardware ===== | ===== Hardware ===== | ||
- | The switch has an [[RTL8380M]] SoC with 8 built-in PHYs, and two [[RTL8231]] GPIO extenders to control the port LEDs, system LED and reset button. | + | * [[rtl838x|RTL8380M]] SoC |
+ | * 2 * [[RTL8231]] GPIO extenders to control the port LEDs, system LED and reset button. | ||
+ | * Macronix MX25L12805D (16MB flash) | ||
+ | * Nanya NT5TU128MBHE (128MB RAM) | ||
Power is supplied via a standard 12V 1A barrel connector. At the back is a hard power-on/ | Power is supplied via a standard 12V 1A barrel connector. At the back is a hard power-on/ | ||
- | A Serial header is already populated with pins and marked with GND TX RX Vcc(3.3V). Serial connection is via 115200 baud, 8N1. Connect TX to TX and RX to RX. | + | A Serial header is already populated with pins and marked with '' |
==== Board details ==== | ==== Board details ==== | ||
Line 16: | Line 20: | ||
It ships with a bootloader based on Realtek' | It ships with a bootloader based on Realtek' | ||
- | ==== OpenWRT | + | ==== OpenWrt |
- | There is complete hardware support in an experimental | + | There is complete hardware support in an experimental |
Original features such as cable integrity tests, offloaded remote mirroring and Port-ACLs are not yet supported. | Original features such as cable integrity tests, offloaded remote mirroring and Port-ACLs are not yet supported. | ||