Old Revisions

These are the older revisons of the current document. To revert to an old revision, select it from below, click Edit this page and save it.

2023/02/28 09:24 gpio_control – oliver +282 B (current)
2023/02/27 12:52 gpio_control – oliver +306 B
2022/07/31 19:13 gpio_control – Add GPIOs from GS1900-24EP svanheule +721 B
2022/07/13 20:41 gpio_control – RTL8380 JTAG mux settings svanheule +44 B
2022/04/22 20:28 gpio_control – Add Cx_IER registers svanheule +226 B
2022/04/22 20:24 gpio_control – Move pinmuxing down svanheule +1 B
2022/04/07 18:56 gpio_control – Add RTL8390 pinmux table svanheule +638 B
2021/11/21 09:12 gpio_control – [RTL8380 pin muxing] Fix table svanheule +6 B
2021/11/21 09:12 gpio_control – [RTL8380 pin muxing] Add GPIO1, 15-18 svanheule +405 B
2021/05/28 18:04 gpio_control – [Registers] Fix IMR_HIGH offset svanheule ±0 B
2021/04/05 12:46 gpio_control – [RTL8380 pin muxing] Correct GPIO port A pins svanheule ±0 B
2021/04/03 08:57 gpio_control – [RTL8380 pin muxing] svanheule +102 B
2021/01/17 15:50 gpio_control – [RTL8380 pin muxing] RTL8380 SPI_SLAVE/UART1 bit svanheule +41 B
2021/01/04 16:42 gpio_control – [External GPIO] Link to RTL8231 page svanheule +4 B
2020/12/12 12:11 gpio_control – [Built-in GPIO] Regroup register tables svanheule -353 B
2020/12/12 12:09 gpio_control – [Built-in GPIO] Make base address more specific svanheule +114 B
2020/12/09 07:12 gpio_control – [RTL8380 registers] Correct high pin range svanheule ±0 B
2020/12/08 12:44 gpio_control – [Pin mux registers] Add bit values for control register svanheule +65 B
2020/12/08 09:45 gpio_control – [RTL8380 registers] Document preable lengths svanheule +66 B
2020/12/07 19:54 gpio_control – Split internal GPIO register in three block, use bus address offset svanheule +207 B