This is an old revision of the document!
Netgear GS108Tv3
Hardware
- RTL8380M SoC
- Macronix MX25L25635F (32MB flash)
- Winbond W631GG8MB (128MB DDR3 SDRAM)
- RTL8231 GPIO extender to control the port LEDs, system LED and a reset button.
Power is supplied via a 12V 1A barrel connector or 802.3af.
A Serial header is found at J1. Pins are Vcc(3.3V, Square), TX, RX and GND. Serial connection is via 115200 baud, 8N1.
Board details
Pin-outs
SoC UART
- J1.1: VCC, 3.3V (square pad)
- J1.2: RX
- J1.3: TX
- J1.4: GND
Firmware
The switch ships with a bootloader based on Realtek's SDK for RTL83xx SoCs and Linux 3.18 based on Realtek's SDK. It has a web interface for basic management, including firmware updates. The web interface must be unlocked to gain access to all management functions. The unlock key is provided after registering the product with Netgear. The board identifies as RTL8393M_DEMO. But this is misleading. The SoC chip id is 83806800, which is RTL8380M_CHIP_ID according to sdk/include/hal/chipdef/chip.h in Realtek's SDK.
Flash layout | |||||||
---|---|---|---|---|---|---|---|
Name | u-boot | u-boot-env | device-info | config | log | firmware1 | firmware2 |
Size | 896k | 64k | 64k | 1M | 1M | 14.5M | 14.5M |